Hard-wired mini cameras with pin-hole lens

Products

RE-TBC3
25x25 B/W mini-camera

RE-TBC3X
As above but without lens

RE-TCC3
30x30 color mini-camera

RE-TCC3X
As above but without lens

RE-TCC3H
20x20 color mini-camera - High resolution 520 lines

RE-TCC3L
30x30 color mini-camera - Low lux

Futher information

Technical data

Table of lenses

Ready-to-hide and wearable cameras

Hidden cameras

Wireless hidden cameras

Instruction for concealment
 

Prices
Price list

Place an order   
How to order

RE-TCC3
Size 30x30 mm.
(RE-TBC3 25x25 mm.)

RE-TCC3L
Size 30x30 mm.
Low lux CCD (0,05 Lux)

Get an idea of the camera size

RE-TCC3H
Size 20x20 mm.
High resolution 520 TV lines

mini-cameras datasheet

   res. 420/520
   low lux version
   audio
   small size
   true image colors

The mini pin-hole lens supplied as standard is a wide angle 3.6 mm lens, but any DSE pin-hole lens can be used. The standard versions are also available without lens in order to enable you to buy the best lens separately without paying the standard one.
>>> See lenses

TIP

DSE produce a vast range of ready-assembled hidden cameras, in both wireless and hard-wired versions

These mini cameras, available in several versions, are specifically designed for discreet surveillance. Not much larger than a coin, they can be installed inside very small objects. The pin-hole lens enables the camera to film through a hole just 1 mm in diameter.

Extra small size
When choosing a mini-camera overall dimensions are very important since these units are very often installed in small places. Using latest technology Micro SMD boards these cameras are smaller than most other CCD mini cameras on the market which are usually based on a 35x35 case.

RE-TBC3	25x25 mm. Depth including std. lens 19 mm.
RE-TCC3	30x30 mm. Depth including std. lens 19 mm.
RE-TCC3H	20x20 mm. Depth including std. lens 22 mm.
RE-TCC3L	30x30 mm. Depth including std. lens 19 mm.

The image on the left gives you an idea of the real dimensions of the products. Smaller cameras cannot be produced nowadays, using CCD sensors.

The camera
In spite of the small size these cameras are developed to provide the same quality level of bigger cameras. Cameras are available in several versions in order to meet any quality and budget requirements. The following table shows CCD brand, resolution and lux of every model.

Standard models RE-TCC3 and RE-TBC3 are suitable for general purposes. RE-TCC3H with high resolution and extra small size is ideal when maximum performance is required. RE-TCC3L, with Sony ExView CCD is recommended for low light applications, considering that minicameras cannot use IR illuminator.

The lens
The cameras come with a special type of lens for concealed use called "pin-holeE lens. This type of lens is able to film through a 1 mm hole, and is therefore perfect to make cameras which are completely invisible even on close inspection.
Cameras are supplied with 3.6 mm pin-hole lens RE-036P, which offers a wide-angle view able to fully cover a small-medium area. Alternatively it is possible to replace the standard lens with any of the other DSE pin-hole lenses from the range below:

RE-036P Flat pin-hole lens - wide angle
RE-036PC As above cone type
RE-062P Flat pin-hole lens - middle angle
RE-062PC As above cone type

Pin-hole lenses are usually flat to ensure minimum depth of the camera. If however the surface hiding the camera is not flat, it could be a good idea to buy the cone lens (shown here) which makes it easier to get the lens closer to the hole.
Further information about the available lenses can be found on the page  LENSES.
When choosing the best lens for your purpose using the lens tables, bear in mind that the camera RE-TCC4 comes with 1/4" CCD while all other models are based on 1/3 CCD.
Low cost models RE-TBC3 /RE-TCC3 can be also purchased without lens, in order to buy the favorite lens separately without having to pay for the standard one.

Audio
All DSE mini cams have a built-in high sensitivity microphone. The microphone is placed beside the lens.
RE-TCC3H, due to the very small size comes without microphone.

Mounting bracket
All cameras come with a mini mounting bracket than can be used or removed according to the application.

Wiring and installation
These cameras can be directly connected to a TV or  monitor using a cable.
They come with a cable  of around 40 cm which has RCA video connector and an audio connector, as well as a plug for the power supply.
To extend this you can use the 20 m cable RE-CT1 (video+audio+power), or for longer distances RG59 coaxial cable.
The cameras take a 12 VDC power supply. To convert 220V mains power into 12 VDC a 220VAC/12VDC adaptor such as  RE-AL4S is used. If you need to control more than one camera you can use a device such as a switcher, quad splitter or multiplexer. Modern digital video recorders do not require these control devices and cameras can be directly connected to their video input terminals.
These mini cams are also available in a wireless version with a RadioEye transmitter.
For those with less experience, or needing to refresh their knowledge, the  tutorials section contains a number of lessons explaining how to wire and install a hard-wired CCTV system correctly.

The product includes
  Camera with mini lens RE-036S or without lens
  Swivel bracket
  Video+audio+power cable 

PLEASE NOTE: Unlike our wireless cameras, these hard-wired mini cams are supplied without a power adaptor, which must be ordered separately (RE-AL4S)

More information

If you are looking for a camera already hidden in an object, please consult the section:
  Hard-wired hidden cameras 

If you would prefer a wireless hidden camera, which does not require any cable to be laid, please consult the section:
  Wireless hidden cameras  

If you are looking for a snake camera or a camera to be hidden among clothes, please consult the section:
  Hard-wired ready-to-hide cameras 

If you want to make your own hidden camera, you will find all the relevant instructions in this section:
  Making your own hidden camera